|
Having run the fuel line down the tunnel I wanted to fit the loom so
that all that had to be run from front to back of the car was
complete. The loom looked complicated and as it states in all good
build guides, a little time taken at this stage to label up the wires
will pay you back later. So, with a photocopy of the manuals wires
descriptions, I spend a couple of hours labeling all of the wires up.
|
|
Before the loom could go in the car, it would have to pass through the
battery panel. Therefore, measured it up and cut it out:
|
|
The hole for the loom needs to be about 5cm in diameter and at a suitable
point where the loom will enter from the tunnel yet under the dash.
Now simply a case of feeding the loom through and running it to the rear
of the car.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
